User Manual

7
VDAS Visual Damage Assessment System
Helicopter spins once.
Team LED flashes
for 2 seconds.
Helicopter spins
once, then spins back.
Team LED flashes
for 2 seconds.
Helicopter spins continuously with
decreased throttle power until it is
on the floor. Team LED flashes for
10 seconds. Hit count is reset for
return to flying.
Aim at opponent’s
hit detector mounted
behind heli gun barrel
Hit #1
Hit #3
Hit #2
Please fly your helicopter, do tests of firing, team color, shot range and the response to hits (VDAS) before going
head-to-head in battle.
Hold your powered helicopters and see if there is a reaction (blinking white LED at Team color LED) when helicop-
ters fire on each other.
Helicopter spins once.
Team LED flashes
for 2 seconds.
Helicopter spins
once, then spins back.
Team LED flashes
for 2 seconds.
Helicopter spins continuously with
decreased throttle power until it is
on the floor. Team LED flashes for
10 seconds. Hit count is reset for
return to flying.
Aim at opponent’s
hit detector mounted
behind heli gun barrel
Hit #1
Hit #3
Hit #2
Get to within 10 feet (3m) of oppo-
nent with short range, and 20 feet
(6m) with long range. Aim at oppon-
tent’s hit detector mounted behind
heli gun barrel.
Note: Distance from the opponent and bright sunlight may interfere with shooting and helicopter response to
shots. Go to www.force-rc.com for battle tactics and tips.
Note: DO NOT use elevator and aileron controls at Hit #3 response or the helicopter may not land safely on
its landing gear. Rudder and throttle controls may used at Hit #3 response.
When firing,
team color LED
blinks white twice.
Target volume is a long egg shape
Press and release either
button to fire at targets
1 second of
weapons
fire sound
Note : 1 second
between shots.
When firing,
team color LED
blinks white twice.
Target volume is a long egg shape
Press and release either
button to fire at targets
1 second of
weapons
fire sound
Note : 1 second
between shots.
Restore Transmitter to Factory Settings
Press and hold down two trim buttons (see illustration)
while pushing power switch to ON. Hold trim buttons
8 seconds. Release trim buttons when tone sounds,
indicating transmitter has been restored to factory
settings. Only transmitter settings are reset with this
procedure. See FORCE Operations Setup Mode instruc-
tions for changing helicopter settings such as shot
range and team color.
Release buttons
when tone sounds.
Hold down 2 trim buttons.
Push Power Switch to ON.
2
1
Hold for
8 seconds