User Manual

8
EN
Aire-Batix
™
B
D
C
A
Battery Installation and ESC Arming
CAUTION: Always
keep hands away
from the propeller. When
armed, the motor will turn
the propeller in response
to any throttle movement.
Battery Selection
We recommend the E-fl ite
®
2200mAh 11.1V 3S 30C Li-Po battery
(EFLB22003S30). Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within
the range of capacity, dimensions and weight of the E-fl ite Li-Po battery packs
to fi t in the fuselage. Be sure the model balances at the recommended CG.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. Apply hook and loop tape (A) to the bottom of your battery.
3. Rotate the battery hatch latch (B) to the left and open the hatch door (C).
4. Install the fully charged battery (D) in the battery compartment as shown.
See the Adjusting the Center of Gravity instructions for more information.
5. Make sure the fl ight battery is secured using hook and loop tape.
6. Close the battery hatch door and rotate the latch to the right to secure the
door.
7. Connect the battery to the ESC (the ESC is now armed).
• The ESC will sound a series of tones (refer to step 6 of the binding
instructions for more information).
• An LED will light on the receiver.