User Manual

6
EN
Aire-Batix
™
Model Assembly Continued
Control Horn and Servo Arm Settings
A
B
C
D
E
F
G
H
Horns Arms
Elevator
Ailerons
Rudder
More control throw Less control throw
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Propeller Installation
IMPORTANT: The propeller size numbers (12 x 8) must face out from the motor
for correct propeller operation.
IMPORTANT: A tool is required to tighten the spinner nut on the collet.
1. Slide the aluminum collet (A) onto the motor shaft follwed by the tapered
aluminum driver (B).
2. Slide the plastic spinner back plate (C) onto the collet.
3. Slide the propeller (D) onto the collet and secure it with the washer (E) and
nut (F).
4. Place the spinner (G) over the propeller and secure it with the screw (H)
provided.
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and sub-trims
to 0, then adjust the clevises to center the control surfaces.