User Manual

5
EN
Model Assembly Continued
A
A
1.
2.
3.
4.
5.
6.
3
2
1
A
B
B
4
5
Wing Installation
1. Insert the front and rear plastic connectors into the wing as shown. Ensure
they are angled to fi t fl ush with the wing surface.
2. Secure the wing halves to the fuselage through the plastic connectors
using three 3 × M4 × 50mm screws (A) provided.
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
Disassemble in reverse order.
Landing Gear Installation
1. Install one landing gear assembly using two 2.6 × 12mm screws (A)
provided. Repeat for the remaining landing gear assembly.
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in
the control horn.
• Move the tube to hold the clevis on the control horn.
Wing Assembly
1. Insert the aluminum wing joining spar (A) into one wing until it stops.
2. Insert the small plywood wing locking plate (B) into the rectangular slot
behind the main wing spar.
3 Slide the remaining wing panel onto the exposed portion of the aluminum
spar and plywood locking plate, ensuring perfect alignment of the two wing
halves.
Tip: A small amount of foam-safe glue can be used for improved security.
4. Carefully route the aileron wires through the slots, ensuring they are not
caught in the wing joint. Connect the included Y-harness (C) to the aileron
servo connectors from the wing halves.
5. Connect the ailerons to the receiver’s AILE (#2 channel) with a Y-harness.
6. Connect the two remaining red female JST plugs from the wing halves to
the two male JST plugs from the circuit board.