User Manual

4
EN
Aire-Batix
™
Prefl ight Checklist
PNP Receiver Selection and Installation
Model Assembly
2
3
2
1
1
A
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
Horizontal Tail Installation
1. With a sharp knife, cut and remove the molded tab from the end of the
fuselage.
2. Fully slide the horizontal tail into the fuselage slot. Ensure that the holes in
the tail line up with the corresponding fuselage holes.
Tip: A small amount of foam-safe glue can be used for improved security.
Vertical Fin and Rudder Installation
1. Install the vertical fi n and rudder assembly into the slot in the top of the
fuselage.
2. Make sure the tail-wheel control wire is inserted into the rudder slot as
shown.
3 Secure the vertical fi n, rudder assembly and the horizontal tail with the 2
included 2.6 × 35mm screws (A) from the bottom of the fuselage.
Tip: A small amount of foam-safe glue can be used for improved security.
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Fully assemble the airplane.
5 Install the fl ight battery in the aircraft (once it has been fully charged).
6 Check the Center of Gravity (CG).
7 Bind the aircraft to your transmitter.
8 Make sure linkages move freely.
9 Perform the Control Direction Test with the transmitter.
10 Perform the AS3X Control Direction Test with the aircraft.
11 Adjust fl ight controls and transmitter.
12 Perform a radio system Range Test.
13 Find a safe open area to fl y.
14 Plan fl ight for fl ying fi eld conditions.
Either the Spektrum AR636 or AR610 receiver is recommended for this
airplane. If you choose to install another receiver, ensure that it is at least a
4-channel full range (sport) receiver. Refer to your receiver manual for correct
installation and operation instructions.
Installation (AR636 shown)
1. Install the receiver in the underside of the fuselage. Refer to the Wing
Installation section of the manual to remove the wings temporarily (if
necessary).
2. Mount the receiver parallel to the length of the fuselage as shown. Use
double-sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.