User Manual

11
EN
1
A
M
B
C
L
D
I
J
K
E
F
G
H
Motor Service
Post Flight Checklist
1
Disconnect the fl ight battery from the ESC (Required for Safety
and battery life).
2 Power OFF the transmitter.
3 Remove the fl ight battery from the aircraft.
4 Recharge the fl ight battery.
5 Repair or replace all damaged parts.
6
Store the fl ight battery apart from the aircraft and monitor the
battery charge.
7
Make note of the fl ight conditions and fl ight plan results, planning for
future fl ights.
CAUTION: Always disconnect the fl ight battery before performing
motor service.
Disassembly
1. Remove the collet (A), driver (B), spinner backplate (C), propeller (D),
washer (E) nut (F), spinner (G) and spinner screw (H) from the motor shaft.
IMPORTANT: A tool is required to remove the propeller nut.
2. Remove the 2 screws (I) and nuts (J) from the cowl (K) and motor mount in
the fuselage.
3. Disconnect the motor wires from the ESC wires.
4. Remove the 4 screws (L) and motor (M) from the motor mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• The propeller size numbers (12 x 8) must face out from the motor for correct
propeller operation.
• A tool is required to tighten the nut on the collet.