Forme - User Manual

9
Standby Mode
The Fontanella will go into Standby Mode (also referred as Sleep Mode) when
Fontanella is idle for more than 28 minutes. This mode helps conserve and save
power when Fontanella is not in use. To restart, hold down the Push Button of the
Control Scroll for several seconds, and the Fontanella will again be ready for use
(Note: It is not necessary to start Fontanella by pressing the ON/OFF Button).
Bio-Filter Water
Caution: When starting up the unit for the rst time, it is necessary to eliminate
every type of produced water (still, cold, hot and sparkling) for the rst 3 litres of
production in order to eliminate the protective anti-bacterial agent introduced at the end
of the testing cycle during manufacture.
During this stage, the produced water may have an unpleasant smell and / or an
altered colour: this will disappear after the dispensing of 3 litres of water that needs
to be discarded. By pressing the PUSH Button on top of the Control Scroll, begin
dispensing water.
Bio-Filter Periodic Replacement
The Bio-Filter system is tted with components that are subject to periodic
replacement. One of the most important parameters affecting maintenance is the
quality of the water (the higher the quality of the water placed in the water tank, the
longer the average life of the component). The Bio-Filter is provided with the
Fontanella and lters approximately 500 litres of water before needing replacement
(depending on quality of water used).
Bio-Filter Alarm
If the Fontanella unit emits an audible intermittent alarm and the red LED in the left side
panel starts ashing with a softly siren, change the Bio-Filter located directly
underneath. Unscrew the Bio-Filter in the left side compartment and replace.
After replacing, dispense and discard the rst 2 litres of water to eliminate the sanitizer
within the new Bio-Filter.
If it should continue emitting the sound and ashing after new Bio-Filter is placed,
please call Technical Support on 1300 881 693.