Forme - User Manual

b) Remove this plug by gently pulling.

c) Fill the ICE Bank through the hole with 900mL of water using the Syringe

provided (requires 18 times lling).

d) Place the plug back in to the hole at the top of the ICE Bank.

Caution: Please DO NOT inject more than 900mL of tap water into the ICE Bank.

Overowing the ICE BANK will cause damage to Fontanella.

3. Fill the Water Tank

Fill in the Water Tank with maximum 3 litres of the tap water (room temperature).

Please do not exceed the MAX line marked. Replace the Water Tank and its Lid onto

its original position. Please make sure that the Water Tank Outlet Piston is rmly

connected with the Water Inlet Piston.

Please open the left-hand side door, checking the Control Box. Make sure that the

Water Source Selection Switch is turned down to “Water Tank” position. Therefore,

Fontanella will only input water from the “Water Tank”.

Caution: Please DO NOT ll more than 3 Litres of water into the Water Tank.

Overow of water will damage Fontanella.

Caution: To prevent the pump from working with no load and overheating, the Water

Tank should never be left without water. Otherwise, it will damage Fontanella.

Caution: Although Fontanella can also be connected to mains water, it is NOT

certied and therefore is NOT to be connected to a mains water supply in Australia.

Caution: In places where the Fontanella is approved to be installed to a mains water

supply, always verify that the inlet water is of a controlled origin (drinkable). Installation

must be done strictly by a qualied technician.

Caution: Verify that the mains pressure is between 2,0 and 3,5 bars: in case the

mains pressure is higher than the maximum allowable value, the carbonation

procedure could be compromised (in such a case, install a pressure reducer). Should

the mains pressure be lower than the minimum value, the electrical appliance will

produce an alarm signal indicating insufcient pressure.

4. Insert CO2 Canister

Please open the left side door on the Fontanella and afx the CO2 Canister. Please

make sure the CO2 Canister is securely locked and rmed with the CO2 Canister

Connector.