Quick Start Guide

成型尺寸: 65x100mm
128g双铜纸，印4C，表面过光油，折页
L3
SmartGlow Light Bulb
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance
of 20 cm or more should be maintained between the antenna of this
device and persons during device operation.
To ensure compliance, operations at closer than this distance is not
recommended.
Les antennes installées doivent être situées de facon à ce que la population
ne puisse y être exposée à une distance de moin de 20 cm. Installer les
antennes de facon à ce que le personnel ne puisseapprocher à 20 cm
oumoins de la position centrale de l’ antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps
éloigné d’au moins 20 cm des personnes pendant son functionnement.
MPE Requirements
EU declaration of conformity
Hereby, VOCOlinc declares that the radio equipment SmartGlow
Light Bulb is in compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following
internet address: www.vocolinc.com
Only use the control provided with or specified by these instructions
to control this lamp.
This lamp will not operate properly when connected to a standard
(incandescent) dimmer or dimming control
This device complies with Part 15 of the FCC Rules / Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Caution:
FCC Declaration
Apple, iPad, iPad Air, iPhone, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries. HomeKit is a trademark of Apple Inc.
Use of the Works with Apple HomeKit logo means that an electronic
accessory has been designed to connect specifically to iPod, iPhone,
or iPad, respectively, and has been certified by the developer to meet
Apple performance standards. Apple is not responsible for the operation
of this device or its compliance with safety and regulatory standards.
Controlling this HomeKit-enabled accessory automatically and away
from home requires an Apple TV with tvOS 10.3 or later or an iPad with
iOS10.3 or later set up as a home hub.
To control this HomeKit-enabled accessory, iOS 10.3 or later is recommended.
Legal Information
Product Overview:
SmartGlow Light Bulb L3 A21 or A67 Light Bulb is a tunable white,
multi-color LED Light Bulb that can be controlled wirelessly via iOS or
Android smartphones and tablets, no hub required. You can customize
your personal lighting using the VOCOlinc LinkWise App from anywhere
with an active internet connection.
Specifications
Input: AC120V, 60Hz or AC220-240V, 50Hz / 60Hz
Base type: E26 or E27
Rated power: 9.5W
LED color range: 16 million colors with cool to warm whites
Color temperature: 2200K – 7000K (including 2200K, 2500K, 2700K,
3000K, 3500K, 4000K, 5000K, 5700K, 6500K, 7000K)
Luminous flux: 850 lumens
Beam angle: 220 degrees
Expected LED life: 22.8 years (25000 hours)
Operation frequency band(s): 2412~2462MHz for E26,
2412~2472MHz for E27
Max. transmitted RF power: 12±1dBm
What’s Included:
L3 Smart Wi-Fi A21 or A67 Light Bulb
Quick Start Guide
E26 or E27 Base
Features:
16 million colors
Works with Apple HomeKit
Works with Amazon Alexa
Works with the Google Assistant
Remote Access
Resetting the smart light bulb can help you troubleshoot any issues you
may have. To reset it to factory defaults:
1. Turn the light switch controlling the bulb to the OFF position.
2. Flip the light switch on and off 3 times. Time lag between each cycle
must not exceed 5 seconds.
The Smart light bulb will blink three times once reset is completed.
Note: all connection data will be cleared. SmartGlow Light Bulb L3 must
be removed from the app and then added back again.
Factory Resetting
* If you set the brightness to 0% before turning off the light switch, the
smart light bulb will resume to 5% brightness as soon as you turn on the
light switch again to indicate that it is in good shape.
L3 SmartGlow Light Bulb LED status
Status
Turning on
the first time
L3
Searching Wi-Fi
Pairing
Device added successfully
Identifying the light bulb
White light at 5% brightness
White light at 5% brightness
White light at 50% brightness
White light at 5% brightness quickly
blinks 5 times
Firmware update completed Blinks twice
Safety Warnings
WARNING: RISK OF ELECTRIC SHOCK OR BURNS. Switch OFF
the light switch controlling the bulb and WAIT for the bulb to cool down
before attempting to change it
DO NOT install the Smart Wi-Fi LED Bulb with wet hands or when
standing on wet or damp surfaces
Not suitable for use with standard in-wall dimmers. Dimmable via the
app only
Suitable for use in operating environment between 0°C and 40°C
(32°F and 104°F)
This device is not intended for use with emergency exit luminaires
For lamps with a weight significantly higher than that of the lamps for
which they are a replacement, attention should be drawn to the fact
that the increased weight may reduce the mechanical stability of certain
luminaires and lampholders and may impair contact making and lamp
retention.
NOT FOR EMERGENCY LIGHTING
For indoor use only
DO NOT disassemble
DO NOT clean with liquid
Use in Dry Locations only
LinkWise APP
Setup code
System Requirements
Mobile device running iOS12.0+ or Android OS4.3+
Existing Wi-Fi network
Stable Internet with good signal strength