Operation Manual

55
BLITZ
G BG B
G BG B
G B
09-19
9.8 PROFILE POSITIONING
(Fig. 09-19)
For correct profile positioning on the work table, first of
all the vice jaws must be suitable for the profile to be
cut. For this reason the specifications are requested at
the time of ordering and it is in any case sufficient to
make requests according to the needs (even later on
if necessary).
The vice jaws are easily positioned on the worktable
because their only reference is a cylindrical pin.
Before positioning the vice jaws a thin film of grease
must be smeared over the contact surfaces to prevent
any swarf from entering.
The cutting quality does also in fact depend on the level
of cleanliness of the work table under the vice jaws.
Correct use of the vice jaw is illustrated in figure
09-20.
Vice jaw Vice jaw Vice jaw
09-20
NO
NO
CORRECT
1
2 3
CAUTION - IMPORTANT
The horizontal work tables are aligned during the machine assembly phase and MUST NEVER BE
DISMANTLED unless by qualified technicians and only in the event of specific necessity, as disassembly
by the user could compromise the correct work table alignment and consequently the cutting precision
of the machine.