Installation Instructions

Installing icemaker tie-downs (Fig. 1)
(Required for some icemaker applications)
Certain icemaker/bin combinations require installation of a tie-down
strap. If this tting has been included with your bin, proceed as follows:
1. Locate back of icemaker ush with back of bin.
2. Using center of vertical slot as a template, drill through icemaker wall
with 15/64 drill.
3. Fasten straps to icemaker and bin (bin holes are predrilled)
with #14 x 1/2 sheet metal screws and washers provided.
Removing lower door assembly
(Only if required for access through narrow doors)
1. With door in closed position, remove Phillips head screw and
washer from hinge area on each side of lower access door.
2. Insert screwdriver between door and hinge bracket on one side
of door and gently push against bracket to provide room for door
stud to clear bracket.
3. Remove access door.
4. Pull up on SmartGATE to remove.
5. Remove screws along top of door assembly.
6. Pull forward on top of assembly and lift to remove.
Reinstalling door assembly
1. Reinstall lower door assembly in bin opening.
2. Reinstall screws in hood at top of door assembly.
3. Reinstall SmartGATE in side panel tracks and push down
to seat.
4. With door in closed position, insert one door stud through hinge
bracket, install washer, screw and tighten.
Note: For proper operation the access door must be reinstalled in
the closed position.
5. On other side, insert screwdriver between door and hinge bracket
and gently push against bracket to provide room for door stud to
clear bracket.
6. Reinstall washer and screw in lift door and tighten.
7. Check door to ensure proper operation.
Operation
SmartGATE operation
Follett’s unique SmartGAT E positively controls the ow of ice into lower door assembly area for removal with either
a scoop or shovel. SmartGAT E can also be adjusted and locked at one of several levels to accommodate ow
characteristics of different types of ice.
Bin is shipped with SmartGAT E in full down position. SmartGAT E can be raised and locked in higher position for better
ow or when more access is needed.
If more ice is needed in lower door area:
1. Use full-length handle at top of SmartGAT E to gently lift and jiggle SmartGATE to encourage ice to ow into access
area of the bin (Fig. 2). (Loose ice will cascade into lower door area.)
2. When adequate ice has owed, push SmartGAT E back down.
2
access door
SmartGAT E
lower door
assembly
icemaker back
bin back
15/64"
hole drilled
through
icemaker
wall
tie-down
strap
Fig. 1