Installation Instructions

Single Door Upright Ice Storage
Bins with SmartGATE
®
Ice Shield
Welcome to Follett
Follett ice storage bins enjoy a well-deserved reputation for excellent performance, long-term reliability and outstanding
after-the-sale support. To ensure that this bin delivers that same degree of service, we ask that you take a moment to
review this instruction before beginning the installation of the bin. Should you have any questions or require technical
help at any point, please call our technical service group at [phone] (US & Canada) or [phone] and in
Poland: [phone].
Before you begin
After uncrating and removing all packing material, inspect the equipment for concealed shipping damage. If damage
is found, notify the shipper immediately and contact Follett Corporation so that we can help in the ling of a claim, if
necessary.
Installation
1. Remove all packing material from bin.
2. Remove all tape and temporary fastenings from door assemblies and outside of bin.
3. Remove top from bin.
4. Remove set of four legs and any other accessories packed inside bin.
5. Lay bin on back, being careful to protect nish, and remove bolts holding skid to bin.
6. Screw legs into tapped holes in bin bottom and tighten to seat legs well against bottom.
7. Set bin upright.
8. Reinstall top onto bin.
9. Remove protective paper from stainless steel exterior.
10. Move bin to permanent location.
11. Adjust “foot” at bottom of each leg to level bin in both directions.
12. Mount icemaker(s) on bin in accordance with icemaker manufacturer's instructions.
13. Connect drain line to 1" FPT female tting located in bottom of bin.
14. Make nal connections to icemaker.
Installing icemaker drain
(Required for some icemaker applications)
Some icemakers require a special drain system. For these machines Follett predrills the hole and provides the 3/4"
straight threaded drain tting to be installed through the hole. To install the tting:
1. Remove plastic nut on tting.
2. From inside bin (liner side), insert threaded portion through hole provided in side of bin.
3. Replace plastic nut on threaded portion and tighten against outside of bin.
4. Connect supplied tubing to icemaker drain connection after installing icemaker.
801 Church Lane • Easton, PA 18040, USA
Toll free [phone] • [phone]
www.follettice.com
207890R07
Installation Instructions and Parts List
Order parts online
www.follettice.com
Important cautions
§ Top is NOT fastened to bin.
§ Avoid excessive tightening force when connecting to the bin drain tting.
§ Do not apply excessive heat if any sweating of ttings is necessary. Heat conduction through
metal may melt threads in plastic drain tting.
§ When leveling, do not extend any leg more than 1 in. (26mm) for total leg height no greater than
2.125 in. (54mm).
§ SDU1000: Legs must be secured to oor through feet to avoid possible movement and resulting
injury.
!