Installation Guide
16 Ice Manager Diverter Valve System Installation Instructions
6
Follett Vision VU155 ice & beverage dispenser
155
Vision VU155 dispenser
ice transport tube and sensor cable
†
• Heat end of transport tube in cup of 160F (71 C)
hot water to soften and spread with pliers
➊
before
making connection to ease assembly and prevent
stainless coupler edge from cutting inner wall oftube
• Install ice transport tube tting in one of four pre-
drilled rear holes in VU155 dispenser
➋
Note: If threaded end extends into dispenser it must
be cut ush to inner nut.
➌
➊
➍
➋
➋
➌
➎
Hot Water
160 F (71 C)
• Attach ice transport tube to tting
➍.
Cut transport
tube to proper length and support the tube at least
every 2 ft. (.6m) to avoid dips or traps that will
result in standing water.
• Connect sensor pigtail to sensor cable
➎
† If VU155 is an existing unit install retrot kit part#
00185165 before completing this portion
of installation (retrot instructions included with
retrot kit).