Installation Guide

10 Ice Manager Diverter Valve System Installation Instructions
➍
front of
dispenser
or bin top
➊
C
L
C
L
front of dispenser or bin top
3-1/2"
(88.9mm) dia.
template
All other dispensers
➎ ➎
➌
➍
➌
front of
dispenser
or bin top
back of
dispenser
or bin top
➋
ED300 dispenser only
4"
(102mm)
4"
(102mm)
4"
(102mm)
R1 3/4"
(19mm)
110CM Symphony Plus w/IMDV
R1.750
5"
(127 mm)
5" (127 mm)
4"
(102 mm)
30” Lancer Sensation and Touchpoint w/IMDV
10.00"
9.00"
4"
ø3.5"
hole saw
C
L
C
L
4 "
(102 mm)
ø3.5"
hole saw
REAR OF
DISPENSER LID
(UNDERSIDE)
Freestyle 9000
FRONT OF
DISPENSER LID
(UNDERSIDE)
Prepare ice & beverage dispenser/bin top
• Using drawing above for your application, locate the
proper location of ice & beverage dispenser (IBD) to
place the supplied template
➊
• Using supplied template and 3.5" dia. hole saw, cut
holes per template
Note: Use a hand saw or similar tool to complete the
cut out.
Mount sensor distribution unit
• Unscrew cap nut and remove center assembly
➋
• Loosen screws and remove cover
➌
• Turn short arm of angle rods so unit can be lowered
into hole of IBD top
• Position unit into IBD top with tube at the front
➍
• Turn angle rods to face outward
➎
• Tighten wing nuts until arms of both rods press rmly
against underside of IBD top securing body of sensor
distribution unit
5
Ice & beverage dispenser/bin