Spec Sheet

3
Form# 8225
Self-contained 710 series ice machine Self-contained 710 series ice machine
1 – Locating the ice machine
Horizon Elite self-contained Chewblet ice machines allow top-mounting or mounting in a base cabinet, on a wall or on a
floor stand up to 75' (22.9 m) from the dispenser or ice bin with RIDE technology. In-cabinet mounting (RIDE applications)
require special attention to service access, unit ventilation and ice tube runs (see pages 4-8).
Top mounting – ice and beverage
dispensers (by others)
RIDE model – Follett low-profile
Vision and Cornelius PR150 ice and
beverage dispensers
Top mount on Follett ice storage bins
Important specifier notes Important specifier notes Important specifier notes
1. Dispenser must be compatible with nugget ice.
See page 4 for compatible ice and beverage
dispenser models and top kit numbers.
2. Verify ceiling or soffit height to ensure sufficient
top clearance.
1. See pages 4-6 for critical clearance and
ventingrequirements.
2. Ice transport tube ships with Vision ice and
beverage dispenser (Vision applications only).
3. Ice transport tube ships with Horizon Elite
icemachine for Cornelius dispensers.
1. See form# B300 for bin sizing.
2. Verify ceiling or soffit height to ensure
topclearance.
3. Locate floor sink or grate and drains in front of
storage bin.
4. Do not position bin drain lines to block
Ice•DevIce
™
bin cart.
RIDE model – ice and beverage
dispensers (by others)
RIDE model – drop-in beverage
dispensers (by others)
RIDE model – Follett ice storage bins
Important specifier notes Important specifier notes Important specifier notes
1. Dispenser must be compatible with nugget
ice. Compatible dispensers include Servend
MD150/175/200/250, SV175/200/250,
MDH-402, and Follett Symphony Plus
™
110CM as
well as the dispensers listed on page 4.
2. Top kit MSF30SC required with Coca-Cola Freestyle
7000. Top adapter 46412 and ice kit 46430 must
also be ordered from Coca-Cola. Top kit HSF26SC
required with Coca-Cola Freestyle 9100. Consult
with Coca-Cola and Follett to qualify application
prior to ordering.
3. RIDE application is approved only for PepsiSpire
3.0, 5.0 and 4.1 designed for top mount ice
machines and requires MSP24SC for 3.0 and
MSP30SC for 5.0 and 4.1, ordered separately. For
manual fill versions of PepsiSpire 3.0, 5.0 and
4.1, contact factory.
4. See pages 4-6 for critical clearance and
ventingrequirements.
1. Compatible with the following dispensers:
Cornelius 1522, 1722, 2323 and Lancer 2200,
2300, 23300.
2. Requires 12.00" (30.5 cm) of access space for
installation on transport tube side.
3. See page 5-6 for critical clearancerequirements.
1. See form# B300 for bin sizing.
2. Locate floor sink or grate and drains in front of
storage bin.
3. Do not position bin drain lines to block Ice•DevIce
bin cart.