Spec Sheet

5
Form# 8225
Self-contained 710 series ice machine Self-contained 710 series ice machine
3 – Undercounter/in-cabinet mounting and ventilation
Using Follett supplied grilles
Horizon Elite ice machines can be installed undercounter/in-cabinet to fill bins or dispensers using RIDE technology. Care must be
taken to ensure proper cabinet venting to avoid recirculation of hot air. Improper venting can cause ice machine outages.
air
in
exhaust
must mate directly
to air intake gasket
12.00" (30.4 cm) minimum
between ice machine
and dispenser
see dispenser
specification
sheet for
installation
requirements
18.00"
(45.7 cm) min.
electric
water
Ice transport tube
minimum 1/4" per foot
(2 cm per meter)
pitch toward ice
machine
secure to prevent dips
and traps from forming
supplied
grilles
Horizon Elite
ice machine
Cabinet door
drain
24.50"
(62.2 cm) min.
22.25"
(56.5 cm)
min.
door & gasket
must mate
directly
cabinet door
2.00"
(5.08 cm)
2.00"
(5.08 cm)
cutout
side of
ice machine
bottom of
ice machine
18.00"W x 14.00"H (45.72 cm x 35.56 cm)
supplied air
intake grille
Cutout for supplied air intake grille
22.25"
(56.5 cm)
minimum
24.50" (62.2 cm) min.
Locating
cutout
Front
Completed installation with
gasket and door in place –
side view
Horizon Elite ice machine
air intake gasket
Important specifier notes for using Follett supplied grilles
1. The supplied exhaust grille must be located at least 18.00"(45.7cm) from the
supplied air intake grille (exhaust air must notrecirculate with intake air).
2. Cabinet interior must be open to allow for unrestricted exhaust airflow.
3. Ice transport tube needs minimum 1/4" per foot (2 cm per meter) pitch toward
ice machine and should be secured to prevent dips and traps from forming.
4. Cabinet door must mate directly to air intake gasket.
5. Cabinet interior must provide a minimum clear space of 24.50" (62.2 cm) deep
by 22.25" (56.5 cm) high.
6. Cutout for supplied grilles must meet minimum size requirements
shownabove.
7. Utilities should be conveniently located as shown.