Installation Instructions

Cornelius • RIDE Technology self-contained

Install the louvered docking assembly.

Louvered docking assembly

DOCKING STATION

(See detail drawing on page 9)

• Prior to installing the louvered docking assembly, ensure that the drain tting is oriented (right

or left) correctly for your installation. An optional straight drain tting is also supplied. You may

need to remove the back panel of the docking assembly in order to re-orient or change the

drain tting. Replace back panel prior to mounting the docking assembly.

• Position and screw louvered docking assembly to the bottom of counter inside of access panel/

door 2" (51 mm) from the front edge of the cross brace

➊

• The mounting surface for the louvered docking assembly must be solid.

Do not mount directly onto runners or channels.

• There must be no lip or edge that would hinder the ice machine from sliding in or out of the

louvered docking station

➋

INTAKE AND EXHAUST GRILLE PLACEMENT: Air-cooled models only

(See detail drawing on page 9)

• Position the intake grille cut out in the access panel/door

Note: Ice machine must be aligned with cut out and inside of access panel to provide a tight

seal and prevent recirculation of hot exhaust air.

• Left edge of cutout should be 2.25" (57 mm) from the left side of the ice machine

➌

• Bottom edge of cutout should be 2" (51 mm) from the bottom of the ice machine

➍

• Position supplied exhaust grille at least 18" (458mm) away from intake grille

➎

Where possible, install exhaust grille to the rear or side of the base cabinet.

• If not using supplied grille, air circulation requirements below must be met:

250 sq. in (1613 sq cm) intake air, 250 sq. in (1613 sq. cm) exhaust air

Undercounter installation requirements Horizon 1010 & 1410 series

4.1

WARNING

• Docking station must be secured in accordance with these instructions to ensure ice machine

stability.

• Ventilation openings in the louvered docking station should be clear of obstruction

Wall bracket accessory Machine stand accessory

• Mount louvered docking assembly to wall

bracket accessory

• Mount louvered docking assembly to

machine stand accessory