Installation Instructions

6
self-contained ICE MANAGER
Install the louvered docking assembly.
Louvered docking assembly
3
WARNING
• Docking station must be secured in accordance with these instructions to ensure ice machine
stability.
• Ventilation openings in the louvered docking station should be clear of obstruction
Wall bracket accessory Machine stand accessory
 • Mountlouvereddockingassemblytowall
bracketaccessory
 • Mountlouvereddockingassemblyto
machinestandaccessory
DOCKING STATION: Horizon 1010 & 1410 water- and air-cooled models
(Seedetaildrawingonpage9)
 • Positionandscrewlouvereddockingassemblytothebottomofcounterinsideofaccess
panel/door2"(51mm)fromthefrontedgeofthecrossbrace
➊
• Themountingsurfaceforthelouvereddockingassemblymustbesolid.
Donotmountdirectlyontorunnersorchannels.
 • Theremustbenoliporedgethatwouldhindertheicemachinefromslidinginoroutofthe
louvereddockingstation
➋
INTAKE AND EXHAUST GRILLE PLACEMENT: Horizon 1010 & 1410 air-cooled models only
(Seedetaildrawingonpage9)
• Positiontheintakegrillecutoutintheaccesspanel/door
Note: Icemachinemustbealignedwithcutoutandinsideofaccesspaneltoprovideatight
sealandpreventrecirculationofhotexhaustair.
 • Leftedgeofcutoutshouldbe2.25"(57mm)fromtheleftsideoftheicemachine
➌
 • Bottomedgeofcutoutshouldbe2"(51mm)fromthebottomoftheicemachine
➍
 • Positionsuppliedexhaustgrilleatleast18"(458mm)awayfromintakegrille
➎
.
Wherepossible,installexhaustgrilletotherearorsideofthebasecabinet.
 • Ifnotusingsuppliedgrille,aircirculationrequirementsbelowmustbemet:
250sq.in(1613sqcm)intakeair,250sq.in(1613sq.cm)exhaustair
Undercounter installation requirements Horizon 1010 & 1410 series
3.1