Owners Manual

ManualsBrandsFollett ManualsCommercial EquipmentDEV700SG-30-BG 30" Single Door DevIce Ice Storage, Dispensing and Transport System with 680 lbs. Storage Capacity, Ice Bagger Kit, SmartGATE Ice Shield and PowerHinge in Stainless Steel

G. Installing 8" (204mm) plastic chute

(for Ice•DevIce models with SmartCART 75, COR package)

1. Orient stainless chute bracket with open end of bracket tabs facing

down.

2. Insert supplied 1/2" 1/4-20 carriage head bolts through bracket and

base and hand tighten only.

3. Gently push on sides of plastic chute to t inside bracket, inserting

bracket tabs into slots in plastic chute.

4. Push up on plastic chute to align holes and secure with supplied

thumbscrew.

5. Tighten carriage bolts holding bracket.

H. Installing 4" (102mm) plastic chute

(for Ice•DevIce models with SmartCART 125, 240 or bagger accessory, and low-prole units)

1. Orient stainless steel chute bracket with open end of bracket tabs facing down.

2. Loosely fasten bracket with two thumbscrews provided through holes into lower door assembly.

3. Install plastic chute into bracket, making sure screw hole is oriented at top.

4. Align hole in chute and bracket with threaded hole in lower door assembly and fasten with thumbscrew.

5. Tighten all thumbscrews.

I. Installing icemaker drain

Required for some icemakers only. For these machines Follett predrills hole

and provides 3/4" straight threaded drain tting to be installed through hole.

To install tting:

1. Remove plastic nut on tting.

2. From inside (liner side) bin, insert threaded portion through hole

provided in side of bin.

3. Replace plastic nut on threaded portion and tighten against outside

of bin.

4. Connect supplied tubing to icemaker drain connection after

installing icemaker.

J. Installing icemaker tie-downs

Required for some icemaker applications only. If this tting is included with

your bin, proceed as follows:

1. Align icemaker back ush with bin back.

2. Using center of vertical slot as template, drill through icemaker

wall with a 15/64 drill.

3. Fasten straps to icemaker and bin (bin holes are predrilled) with

#14 x 1/2 sheet metal screws and washers provided.

K. Final connections (for all models)

1. Install supplied 1" elbow into drain tting under bin.

2. Connect customer supplied length of vinyl tube to barb end and route to either side or rear of bin (so not

to interfere with cart movement).

3. Make nal connections to icemaker.

Avoid excessive tightening when connecting to this tting.



Fig. 5

bracket

chute

Fig. 4