Owners Manual
11. Lower upper section onto lower section, taking care not to disturb gasketing material and sealant beads.
12. Remove protective covering from stainless steel surfaces.
13. Install icemaker according to manufacturer’s instructions.
14. From inside bin (access can be gained through lower door assembly) seal entire perimeter of seam
between upper and lower sections with General Electric RTV 180 sealant provided (Figs. 2, 3).
15. Install supplied screws on side H-bracket and tighten, then seal entire perimeter of H-bracket with silastic.
16. Use supplied screws with a power driver to install tool bracket in holes on either side of Ice•DevIce.
17. Insert short side of inspection window through notch in upper and lower track and continue to rear groove.
Repeat with second window only to front groove.
18. Remove any remaining protective covering or temporary fastenings from doors and outside of bin.
F. Installing bin section
(for low-prole Ice•DevIce models only)
1. Remove all packing material from bin.
2. Remove set of four legs and any other accessories packed inside bin.
3. Remove top from bin.
4. Lay bin on its back being careful to protect nish and remove bolts holding skid to bin.
5. Screw legs into tapped holes in bin bottom and tighten to seat legs well against bottom.
6. Set bin upright.
7. Remove protective covering from exterior.
8. Move bin to permanent location.
9. Adjust “foot” at bottom of each leg to level bin in both directions.
10. Mark position of each anged foot anchoring hole.
11. Move base section out of the way and install anchors
for 1/4" bolts in oor (supplied by others).
12. Reposition unit in its intended position.
13. Anchor base unit to oor through anged feet.
14. Mount ice maker.
8
upper section
lower section
bin exterior
bin interior
Seal entire inside
of upper and lower
section seams and
entire perimeter
of H-bracket with
silastic provided.
H-bracket
screw
bead of sealant
Completely cover gasket material with sealant. Failure to properly seal sections may
result in leakage and/or ice contamination, and will void warranty.
!
Fig. 2 – Cross Section, Side View
Fig. 3 – Bin Cutaway
Follow Steps 11 - 15 to anchor upper and lower sections of all two-section upright
bins. Brackets must be installed to avoid possible injury should unit move.
!