Owners Manual

SmartCART 125
Assembly
The cart will arrive to you fully assembled. Check that the drip shelf inside
the cart is horizontal, with the hole oriented toward the front.
Operation
1. The cart is highly maneuverable with two swivel casters in front.
2. The polyethylene construction is resistant to damage
from normal use, and prevents it from marring walls and xtures.
3. A hand valve at the front of the cart allows melt water or cleaning
solutions to be easily drained from the cart. The valve has a
threaded tting, allowing a hose to be connected, if desired.
4. The cart is capable of holding approximately 125 lbs (56.7kg) of ice.
Filling cart
1. Open cart lid and position cart directly under ice chute.
2. Open lift door and conrm that there is enough ice in hopper area. (If not, see previous sections on
“adjusting SmartGATE” and “using tools”.)
3. Pull chute gate up to start ow of ice into cart.
4. When cart is almost full, push gate down to stop ow. (Some ice will continue to fall as chute gate closes.
Leave room in cart for this in-ight ice to avoid spillage.)
5. Check that drain valve is closed.
6. Wheel cart to usage area. Lock caster before unloading
Cleaning
1. The cart can be cleaned using a mild detergent and a soft brush, taking care not to mark the surface.
2. If stains appear, a mild cleaning compound can be used.
3. Periodic cleaning and sanitizing should be done with any product
suitable for use in a food zone.
4. Remove and clean faucet regularly. Use a small brush to access faucet body and spout. Replace
faucet properly to avoid leaks.
14
Clean and sanitize cart interior prior to use and on regular schedule as needed thereafter
to ensure cleanliness of delivered ice.
!