Spec Sheet

Single door Ice•DevIce
9720-201912 | © Follett LLC
Specification
Maximum bin capacity  see model table below
W1 Bin width see model table below
D1 Bin depth 31.00" (78.7 cm)
Bin depth with lower door assembly ² 39.00" (99.1 cm)
D2 Bin depth with door fully extended 49.50" (125.7 cm)
H1 Bin height  (adjustable) see model table below
H2 Bin base height  (adjustable) 24.75" (62.9 cm)
H3 Bin base clearance
5
(adjustable) 21.62" (54.9 cm)
Required door access
5
32.00" (81.3 cm)
W2 Cart width 21.50" (54.6 cm)
D3 Cart depth 34.00" (86.4 cm)
H4 Cart height at front edge 20.50" (52.1 cm)
H5 Cart height with lid up 38.62" (98.1 cm)
L1 Drain 
1.00" FPT, center of bin bottom
(drain elbow supplied)
Dispense rate
up to 5 lb (2.3 kg) per second
Ice compatibility
cube ice and Chewblet ice
Approximate ship weight see model table below
NOTE: For indoor use only
SHORT FORM SPECIFICATION: Ice•DevIce system to be Follett model ____________ elevated bin,
base, and ice transport cart system with front ice chute and industry-exclusive SmartGATE ice
shield. Bin to hold approximately ______ lb (kg) of ice. Exterior finish of bin and base to be full
stainless front, sides, back and bottom. Bin liner to have non-corroding polyethylene walls and
stainless steel bottom. Bin insulation to be CARB compliant non-HFC foam, bonded to shell and
liner for added structural strength. Bin top to be ABS and custom-cut for ice machine(s) to be
used. Lower door assembly to include non-corroding poly access door, poly lift door with
PowerHinge to eliminate gasket and latches, and inner SmartGATE to positively control ice flow
into access door area. Entire lower door assembly to be easily removable for installation through
narrow doors. Upper inspection window (on all models except DEV500SG-30, DEV860SG-48
and DEV1080SG-30) to be double-wall poly to increase durability and minimize ice melt and
condensation. Cart base to be rotomolded polyethylene with hinged plastic lid and drain. Totes
to be of one-piece, molded poly with swivel handle. Cart and Totes to store below bin when
not in use. All models to be equipped with flanged, adjustable feet, paddle and rake tool set.
NSF listed.
Dimensional drawing
H5
H4
D3
L1
C
L
C
L
H3
H2
D2
H1
D1
W2
W1
FLEXI-TOP, ICE•DEVICE, POWERHINGE, SMARTCART and TOTES are trademarks of Follett LLC.
CHEWBLET, FOLLETT and SMARTGATE are registered trademarks of Follett LLC, registered in the US.
Follett reserves the right to change specifications at any time without obligation. Certifications may
vary depending on country of origin.
Model
with
SC75 cart
with
SC125 cart
with
Cambro cart
with
Totes
ice carrier
4
with
bagger kit 
Maximum
bin capacity
lb (kg) 
Cubic volume
cu ft (m)
Width - W1
in (cm)
Height , - H1
in (cm)
Approximate
ship weight
lb (kg)
DEV500SG-30 
-75 -125 -ICS125L -LP -BG 460 (209) 14.80 (0.41) 30.00 (76.2) 63.00 (160.0) 354 (161)
DEV700SG-30
-75 -125 -ICS125L -LP -BG 680 (308) 21.70 (0.61) 30.00 (76.2) 78.50 (199.4) 389 (177)
DEV860SG-48
-75 -125 -ICS125L -LP -BG 860 (390) 25.50 (0.72) 48.00 (121.9) 65.50 (166.4) 452 (206)
DEV1010SG-48
-75 -125 -ICS125L -LP -BG 1000 (454) 31.90 (0.90) 48.00 (121.9) 74.50 (189.2) 453 (206)
DEV1175SG-48
-75 -125 -ICS125L -LP -BG 1185 (538) 37.60 (1.06) 48.00 (121.9) 80.50 (204.5) 483 (219)
DEV1300SG-48
-75 -125 -ICS125L -LP -BG 1320 (599) 41.90 (1.19) 48.00 (121.9) 84.00 (213.4) 476 (216)
DEV1160SG-56
-75 -125 -ICS125L -LP -BG 1170 (531) 37.30 (1.06) 56.00 (142.2) 74.50 (189.2) 472 (214)
DEV1350SG-56
-75 -125 -ICS125L -LP -BG 1360 (617) 43.20 (1.22) 56.00 (142.2) 80.50 (204.5) 521 (236)
DEV1080SG-60
-75 -125 -ICS125L -LP -BG 1080 (490) 34.30 (0.97) 60.00 (152.4) 65.50 (166.4) 490 (222)
DEV1325SG-60
-75 -125 -ICS125L -LP -BG 1325 (601) 42.00 (1.19) 60.00 (152.4) 74.50 (189.2) 518 (235)
DEV1475SG-60
-75 -125 -ICS125L -LP -BG 1490 (676) 47.40 (1.34) 60.00 (152.4) 80.50 (204.5) 517 (235)
DEV1650SG-60
-75 -125 -ICS125L -LP -BG 1660 (753) 52.80 (1.50) 60.00 (152.4) 84.00 (213.4) 532 (241)
Notes:
 Computed on cubic volume of bin. Does not reflect cart capacity or voids that can occur due to pyramiding.
 Lower door assembly easily removed for installation access.
 Special top required for ice machines weighing more than 1000 lb (454 kg). Add 0.5" (1.27 cm) to height. Contact factory.
 10.00" (25.4 cm) flanged legs available which replace base unit, height from floor to bottom of chute equals 15.50" (39.4 cm), overall height reduced by 14.75" (37.4cm).
Includes one Totes ice carrier instead of cart and uses 4.00" (10.16 cm) chute.
 Required clearance for installation access through doors (may require removal of lower door assembly).
 Follett recommends installation of a floor drain with grate with all ice storage bins. Consider cart positioning when locating the drain.
Clearance required to pull cart from below bin — minimum 36.00" (91.4 cm), optimal 40.00" (101.6 cm).
 DEV500SG-30, DEV860SG-48 and DEV1080SG-60 do not have upper inspection window.
 Bagger kit includes 250 plastic bags of 10lb(4.5kg) capacity.
Follett Europe Polska Sp. z o.o.
Mokry Dwór 26C 83-021 Wiślina, Poland
[phone] | Fax: [phone]
folletteurope.com
801 Church Lane | Easton, PA 18040, USA
1.610.252.7301 | Fax: [phone] | follettice.com