Owners Manual

16
Bagger Accessory
Assembly
1. Attach tape dispenser to left side of bagger assembly for
right-handed users using two screws provided.
For left-handed users, attach to right side.
2. Center tape roll on tape drum Fig. 7, as shown, to dispense
tape with adhesive side up.
3. Place tape drum with tape in slot Fig. 8 and pull tape lead end
forward to front edge of bag sealer.
For ease of use, the bagger assembly can be attached to the bin
using a Velcro strip that has been provided on the back of the
bagger. Clean the front of the base under the chute of all dirt and
oil, peel the backing off the Velcro strip to expose the adhesive,
and press the bagger assembly against the base.
Operation
1. The bagger accessory is used to ll 10 lb (4.65kg) bags of ice
easily and with minimal spillage (optional 8 lb (363kg) bags
are also available when reordering).
2. A “ag” type of seal, using the enclosed tape dispenser, is
formed by a single strip of pressure-sensitive tape that
encircles the neck of the bag.
Filling bags with ice and sealing:
1. Position bagger assembly in front of bin below ice chute.
2. Hang wicket with bag on bracket behind white plastic funnel of
bagger accessory.
3. Pull one bag open under white funnel.
4. Open bin door and pull up on ice chute gate to dispense ice.
5. Begin to close gate when bag is about half full.
6. To seal ice bag, twist neck of bag to be sealed and position at
90-degree angle over bag slot Fig 9., as shown.
7. Move bag neck downward to bottom of slot and pull sideways
to remove sealed bag neck from bag sealer.
Cleaning
1. The plastic funnel should be cleaned and sanitized periodically
with any product suitable for use in a food zone.
2. The aluminum stand can be cleaned with mild detergent.
Fig. 7
Fig. 8
Fig. 9
Fig. 6