Owners Manual
Filling Totes ice carriers
1. Lift lid. Position ice carrier closest to cart handle under ice chute.
2. Open lift door and conrm there is ample ice in hopper area. If not,
see previous sections on adjusting SmartGAT E
and using tools.)
3. Pull chute gate up to start ow of ice into ice carrier.
4. When ice carrier is almost full, push chute gate down to stop ow.
(Some ice will continue to fall as chute gate closes. Leave room in
ice carrier for this in-ight ice to avoid spillage.)
5. Pull cart forward until next ice carrier is under chute and repeat steps
3 and 4.
6. Check that cart drain is closed and wheel cart to usage area.
Note: For better cart stability when removing Totes ice carriers:
remove ice carrier closest to cart handle rst, then proceed to middle
ice carrier, ending with ice carrier farthest from cart handle.
13
The Totes ice carrier must be cleaned and sanitized prior to use. A regular schedule of
cleaning maintenance is recommended following installation to ensure cleanliness of
delivered ice. Do not run ice carrier through any dishwashing system.
!
Pull up on chute gate to allow ice to
ow into ice carrier
Cleaning
The polyethylene Totes ice carrier should be cleaned and sanitized periodically with any product suitable for use
in a food zone.