Owners Manual

3
Installation
1. Remove all packing material from bin.
2. Remove all tape and temporary fastenings from door and outside of bin.
3. Remove set of four legs and any other accessories packed inside bin.
4. Lay bin on its back, being careful to protect  nish, and remove bolts holding
skid to bin.
5. Screw legs into tapped holes in bin bottom and tighten to seat legs well
against bottom.
6. Set bin upright and move to permanent location.
7. Remove protective paper from stainless steel surfaces.
8. Adjust “foot” at bottom of each leg to level bin in both directions.
9. Mount icemaker(s) on bin in accordance with icemaker manufacturer’s
instructions.
10. Connect drain line to 1" IPS female  tting located in bottom of bin.
11. Make  nal connections to icemaker.
Lift door catches (Fig. 1)
1. Position lift door in upright position.
2. Center catch on icemaker front above door and position catch to securely
hold door when open.
3. Drill two (2) 7/64 (2.78 mm) holes through catch holes and into icemaker
face.
4. Install catch using two (2) #6-1/2 sheet metal screws supplied.
Icemaker tie-downs (Fig. 2)
(Required for some icemaker applications only)
Certain icemaker/bin combinations require the installation of a tie-down strap.
If straps have been included with your bin, proceed as follows:
1. Locate icemaker back  ush with bin back.
2. Using center of vertical slot as a template, drill through icemaker wall with
a 15/64" (5.95 mm) drill.
3. Fasten straps to icemaker and bin (bin holes are predrilled) with
#14 x 1/2 sheet metal screws and washers provided
Icemaker drain
(Required for some icemaker applications only)
Some machines require a special drain system. For these machines Follett
predrills the hole and provides a 3/4" straight threaded drain  tting to be installed
through the hole. To install the  tting:
1. Remove plastic nut on  tting.
2. From inside bin (liner side), insert threaded portion through hole provided in side of bin.
3. Replace plastic nut on threaded portion and tighten against outside of bin.
4. Connect supplied tubing to icemaker drain connection after installing icemaker.
Cleaning and sanitizing
Interior bin cleaning
Follett slope front ice storage bins are equipped with polyethylene liner walls and stainless steel bottoms that
should be cleaned and sanitized prior to use and periodically with any cleaning and sanitizing products suitable
for use in a food zone.
Important: Follett Corporation recommends installing a properly-sized, activated carbon (charcoal) water  lter on
water supply to icemaker to remove chlorine.
Exterior bin cleaning
Exterior stainless steel surfaces can be cleaned with a stainless steel cleaner such as 3M* Stainless Steel
Cleaner & Polish or equivalent.
* 3M is a registered trademark of 3M Company in the US and other countries.
catch assem
lift door
front of icemaker
Fig. 1
icemaker back
bin back
15/64"
(5.95 mm)
hole drilled
through
icemaker
wall
tie-down
strap
Fig. 2