Installation Guide

25FB425A/W, 50FB425A/W 5
Fig. 1 – Rear connections, freestanding models
2.81" (7.2 cm)
2.775" (6.9 cm)
3.75" (9.5 cm)
2.9" (7.6 cm)
10.62" (27 cm)
9.62" (24.4 cm)
12.38" (31.4 cm)
14" (35.7 cm)
31.5" (80 cm)
33.75" (85.8 cm)
50fb
3/8" FPT condenser outlet location
(water-cooled only)
3/4" MPT icemaker drain location
access panel
3/8" FPT
water inlet
3/4" MPT drain
power cord
3/8" FPT condenser outlet location
(water-cooled only)
10. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull
forward.
11. If dispenser is equipped with SensorSAFE remove protective plastic coating from dispense sensor labels.
12. Turn on dispenser power and bin signal rocker switches. Check dispenser and ice machine operation.
13. Clean ice machine according to cleaning section. Discard ice made during cleaning process.
14. Turn off ice machine bin signal switch.
15. Remove dispenser hopper lid; clean dispenser according to instructions in Cleaning section.
16. Turn ice machine bin signal switch on and replace front covers, securing with screws.