User Manual

9
Rear Panel
1. Network Port 1 / Primary Power Input*
RJ45 [etherCON] connector for the Dante network. Use standard Cat 5e or Cat 6 network
cables to connect RedNet X2P to an Ethernet network switch.
Power over Ethernet (PoE) can be used to power the RedNet X2P. Connect an appropriately
powered Ethernet cable to network port 1.
2. Network Port 2
Second RJ45 [etherCON] network port which can be used to daisy-chain additional devices.
This port does not accept PoE input and does not pass power out.
This port cannot be used as the secondary connection on redundant networks – network ports 1 and 2 always
function as a 2-port switch.
3. Secondary Power Input*
DC input with locking connector for use where Power-over-Ethernet (PoE) is not available.
Can be used in conjunction with PoE.
When both power supplies are available PoE will be the default supply.
4. Line Out XLRs
Two balanced output channels which can, for example, be used for monitor loudspeakers.
(Passive speakers will require external amplification). Software selectable +18 / +24 dBu
maximum output level.
5. Local Analogue inputs
Combo connectors for Local Mic/Line or Instrument inputs. Balanced XLR for Mic/Line
sources, mono TS jack for instrument input; automatic detection of input type. +48V phantom
power will be disabled when a 1/4” TS jack is inserted.
*For health and safety reasons, do not power-up RedNet X2P while monitoring through headphones.
Refer to the Appendix on page 16 for the connector pinouts.
13 4 52