User Manual
Table Of Contents
6
7. Input Mix Switch
Press to send the combined Network/Local mix signal to the Line Output XLRs. When not
active the Line Outputs will receive the Network signal only.
Press-and-hold for 1.5 seconds to display the Line/Headphone output signals on the LCD
display’s level meters. The signals will be visible while the switch remains pressed.
8. Mute Switch
Press to mute the Line output XLRs. Power-up state is congurable from the Tools menu.
Press and hold for 1.5 seconds to activate the Reverse ID function which will highlight the
device in RedNet Control. Reverse ID will be active while the switch remains pressed.
9. Link Switch
Press to combine the Local Input Gain encoders so they affect both channels. When Link is
active, changing the level of either encoder will alter both channels by the same amount. Any
existing offset between the two channels will be maintained.
Note that the action of the link switch will be modied if the “Auto” option is selected from the Tools menu. In
this mode, the Line and Headphone outputs will switch between Stereo (Link on), and Mono-Summed (Link
off) – where each Local input becomes a mono source feeding both the Left & Right outputs.
Press-and-hold for 1.5 seconds to activate Front Panel Lockout. See page 12 for full description
of Lockout options.
Top Panel . . . Continued
7
8
9