User Manual

43
Subnet Mask set to 255.255.255.0:
Press the setup key to exit setup and your setting will be saved.
Now power down the console and restart your Apple computer.
Once booted, ensure that the Focusrite Control 2802
application is running and open on your DAW machine. Finally
power up the console.
After the console boots, it should be picked up by Focusrite
Control 2802 software (you may have to repeat the power down
/restartprocessifyouareexperiencingdifculties).
The Control 2802 software should indicate detection of the console
and should also show you the serial number of the console.
Select the console and click on the connect button to the
bottom right >>
Your console should now be connected to your studio DAW
computerandreadyforcongurationasaHUI
TM
control surface
and analogue automation platform.
Setting up the console with DHCP
(for use with routers)
If you have more than one device connected to your DAW
computer, you will most likely be using a network router to talk
to all of these devices.
If you have connected Control 2802 to your DAW computer via a
network router, you will need to use DHCP to enable automatic
congurationofIPaddress,providingfastandsmarternetworking.
Ensure that you enable DHCP in your DAW computer system
preferences (you should already know how to do this if you are
running an existing network).
You will most likely be running DHCP with automatic IP hand out.
Ensure that the console is set to use DHCP on the second page
of the setup menu, once set reboot the console and follow the
same connection procedure as outlined previously once the
console is detected.
Port set to 1212: