Operation Manual

You’ll see that as you change the source selection for an output, the right hand side of the window

displays a graphic illustrating the routing. For simple one-to-one routings, the graphic looks like

this:

4. Fader – use this to adjust the signal level at the output. Note that all output levels are set to

maximum as a default (unity gain). If the fader “knob” is green, it means that control of the

output level is assigned to the physical MONITOR control on the Clarett’s front panel. This

assignment is made on the Device Settings page; see page 27.

5. MUTE – click this button to mute/unmute the output.

6. STEREO – assigns the output to be either one of a stereo pair or an individual mono output. In

stereo mode, all output functions apply to both outputs forming the stereo pair.

7. Meters – A bargraph meter (two if conﬁgured for Stereo operation) is provided indicating the

audio level at the output. A red audio overload icon appears when the output level clips. This

icon can be cleared by clicking anywhere in the meter bar.

As well as all the functions above, the Monitor Outputs also have one additional control, a DIM button.

When active, Dim reduces the level in the monitors (the amount of reduction is determined by the

Clarett device connected).