Operation Manual

MIXING & ROUTING PAGE

Installing Focusrite Control on your computer will place an FC icon on the dock or desktop.

Click the icon to launch Focusrite Control. You should see a screen similar to that below:

The green Sync ‘LED’ at the screen top left should be illuminated; this conﬁrms that the Clarett

device is locked to a valid clock source. See page 29 for further information.

Note that in addition to the main window, there is a dialogue box conﬁrming that the

computer is correctly connected to the hardware interface. This box also offers you some

options that let you quickly conﬁgure or reconﬁgure the software. These are covered later

in the User Guide, so if you are just starting out with Focusrite Control, you may safely

close this dialogue box.

NOTE

If, instead of the above, you get a warning message stating No Hardware Connected, this

means that the computer has been unable to establish communication with the hardware.

In this case, please check:

• that the Thunderbolt cable is correctly plugged in at both ends, and that the cable

or connectors are not damaged in any way,

• that the Clarett interface is turned on.