Operation Manual

6 Control 2802 Operating Manual
Installation
Installation
Package Contents
Your packaging should contain the following:
● Control 2802 console
● IEC power cord
● CD containing the documentation and drivers.
Check for any signs of transit damage. If any signs of
mishandling are found please notify the carrier and inform your
dealer immediately.
Important Safety Instructions
Please read all of the safety instructions at the beginning of this
manual before connecting to the mains and powering up the
console. To prevent electrical shock and re hazard, follow all
warnings and instructions marked on the rear of the console.
This unit if connected via its IEC power cord to the mains
safety earth.
NEVER OPERATE THIS CONSOLE WITH THIS EARTH
CONNECTION REMOVED.
Internal Switch Mode Power Supply & Mains
Fuse
The console utilises an internal switch-mode power supply
that is very quiet and passively cooled with plenty of current
capability and headroom. This switch-mode design will accept
any A.C line voltage from 100-240v ±10%. Therefore, the
console will work anywhere in the world provided that your A.C
mains line voltage is within this specication.
Consult a qualied technician if you suspect difculties.
Do NOT attempt to tamper with the power supply or mains
voltages – HAZARDOUS TO HEALTH.
Always replace the mains fuse with the correct value – T2A
slow blow.
Power Up
On power up, please check that the power rail indicators for
+48v d.c and +/-18v d.c light on the top right hand side of the
console:
Service and Repair
The console uses a complex internal PCB sandwich
arrangement making eld service only possible by a qualied
technician.
If any technical issues do arise with your console, please
contact your dealer as soon as possible to arrange for
technical support.
Do NOT attempt to x the console unless qualied to do so.
See the warranty information at the beginning of this manual
for details of your cover.
Dimensions (including rubber feet)
● Height Front: 60 mm
● Height Rear: 170 mm
● Width: 450 mm
● Depth: 550 mm
Ventilation
Care should be taken not to obstruct the series of ventilation
holes in the metalwork of the console. The unit is designed
to release heat and take adequate air ow via these holes to
ensure longevity of performance.
These can be found along the left hand bottom edge on
the side panel (below the cheek), the rear top wrap-around
ventilation panel and below the faders at the foot of the
console.
If mounting the console into some form of studio furniture or
desk, please ensure that there are sufcient air gaps at these
locations:
Lexan Overlay
The front panel at the top of the console (dark section only)
features a rugged under-surface printed polycarbonate overlay.
Exposure to direct sunlight for extended periods of time should
be avoided as this can have a detrimental effect on the overlay
panel and the control knobs.