Operation Manual

46 Control 2802 Operating Manual
Connector Wiring & Specications
Connector Wiring & Specications
For an overview of the rear panel connections, please see
page 8. This section provides technical data including
wiring and pin-out diagrams.
XLR Connections
All XLR balanced input and outputs are wired as:
● Pin 1 shield (chassis/shield ground)
● Pin 2 hot (+ve)
● Pin 3 cold (-ve)
TRS Jack Connections
All 1/4” TRS jacks are wired as:
● Tip (+ve)
● Ring (-ve)
● Sleeve (shield)
Channel Strip Inputs and Outputs
Each of the 8 channel strips provide:
MICROPHONE INPUT (balanced, female XLR):
● Input impedance is >2.5k Ohms.
● Maximum input level is approx. +16dBu
(where 0dBu is referenced to 0.775Vrms).
LINE INPUT (balanced, 1/4” TRS jack):
● Input impedance is >10k Ohms.
● Maximum operating level is +27dBu.
INSERT SEND (balanced, 1/4” TRS jack):
● Output impedance is 150 Ohms.
● Drive capability is +21dBu.
INSERT RETURN (balanced, 1/4” TRS jack):
● Input impedance is >10k Ohms.
● Maximum input level is +21dBu.
25-pin D-Sub Connections
The remaining channel strip connections and Summing Input
are found on three 8-way female DB25 connectors at the
bottom of the rear panel:
DB25 Tascam DA-88 Wiring Specication
Each conforms to the Tascam DA-88 wiring specication for an
eight-channel balanced analogue 25-pin D-Sub as follows:
DAW INPUTS 1-8 (balanced, 8-way female DB25)
● Input impedance is >10k Ohms.
● Maximum input level is +27dBu.
DIRECT OUTPUTS 1-8 (balanced, 8-way female DB25)
● Output impedance is <75 Ohms.
● Maximum output level is +27dBu.
SUMMING INPUT 1-8 (balanced, 8-way female DB25)
● Input impedance is >10k Ohms.
● Maximum input level is +27dBu.