Operation Manual

34 Control 2802 Operating Manual

Aux Masters

Control 2802 has two mono aux buses with a simple set of

master controls:

● LEVEL - master level of the aux output.

● PRE - switches channel aux sends from post-fader to

pre-fader. Note that the sends from ALL 8 channels are

affected.

Signal leaves the console via the balanced male XLR outputs

(AUX O/P 1 & 2) on the rear panel.

Monitoring the Aux Buses

Each of the aux busses may be selected as a control room

or Cue/FB monitor source. This makes it easy to listen in the

control room while building an aux mix, and/or to use auxes to

feed artists heaphones (via the cue output).

To monitor an aux bus in the control room:

Select AUX 1 or AUX 2 from the MONITOR SOURCE section.

Then press MIX/SRC so that SRC is selected:

Please note that monitor sources sum if you make more than

one selection. So, make sure that you deselect the other

options if you wish to monitor an aux bus in isolation.

Aux 1 Signal Flow (Aux 2 is identical):