Operation Manual

22 Control 2802 Operating Manual
The Channel Strip
Cue Alternative Input Select
This switch activates the alternative cue input. When active, the
cue source is determined by the DAW input ip (8) as shown in
the diagram below.
● ALT I / P DOWN + DAW UP - the mic/line input feeds the
main channel while the DAW return feeds the cue section.
By adding the stereo cue bus to the main mix in the master
section (ASSIGN TO MIX - CUE), the DAW return can be
used as an extra mix input. The DAW input level and pan are
controlled from the cue “send” (11 & 13).
● ALT I / P DOWN + DAW DOWN - the mic/line input feeds
the cue bus while the DAW return feeds the main channel.
This can be used in the same manner as above (with the
inputs reversed). Or, it can be used to generate a zero
latency cue send for your artist’s headphones. See page
19 for details.
The ALT I/ P can be selected on a channel-by-channel basis,
producing some very exible routing combinations.
ASSIGN TO MIX
The ASSIGN TO MIX - CUE switch, in the master section,
routes the cue bus onto the main mix. Note that ALL cue sends
feed the main mix when this switch is active.