Operation Manual

12 Control 2802 Operating Manual

Monitoring Audio (Quick-start)

Each channel has 3 inputs: MIC, LINE and DAW.

The default input is mic. To change input, select either

LINE (4) or DAW (8).

DAW overrides MIC/LINE as the DAW return is inserted at

a later point in the channel signal ow.

To get signal from the MIC input to the MAIN SPKR L/R

outputs (on the rear connector panel):

1. With the mic input selected, adjust the mic gain (3)

and 48V phantom power (2) - you should see input

level on the channel meter (1).

If not, check that CH METER SELECT in the centre of the

console is set to INPUT (in the UP position):

2. Select MIX bus assign (17) to route the channel to the

main mix bus, and open the channel fader (22).

The fader can ip between controlling the analogue

channel level or a DAW fader. So make sure that the DAW

switch, located on the Control Surface Panel, is NOT

illuminated so that you are controlling the analogue layer:

3. Then open the master fader - you should see level on

the LEFT & RIGHT MIX meters:

If not, check that the channel is not CUT (20) or that a

different channel is not in SOLO (21).

Also check that MIX is selected as the MONITOR

SOURCE in the Monitor Section (9).

4. Open the monitor VOLUME control (10) and you

should be hearing audio!

If not, check that:

● The MONITOR SOURCE is not switched to SRC (9).

● The monitor CUT and DIM (16 & 17) are not active.

● The individual L R monitor cuts are not active (14 & 15).

● The ALT SPKR switch (19) is not selected.

5. To listen on headphones, engage the headphones

ON switch (22), make sure that CUE/FB TO PHONES

(19) is off, and turn up the PHONES volume (20) -

the control room monitor output is now sent to the

headphone jack connector on the rear connector

panel.