Operation Manual
DAW Control / Fader Automation Overview
Control 2802 Operating Manual 11
DAW Control / Fader Automation Overview
The lower part of the control surface can remotely adjust parameters within the DAW software, and respond to HUI
TM
/ MIDI
automation allowing you to automate both the DAW and analogue fader layers. To use these features you must connect Control 2802
to your DAW computer via Ethernet, and congure the DAW software to support Control 2802 as a HUI
TM
control surface.
You can nd full details on the setup and operation in the “Automation & Control Surface Manual” which can be downloaded from our
website at at www.focusrite.com. Here you will nd separate documents for each of the major DAWs: ProTools, Logic Pro and Cubase.
Dual Layer Fader Strips
The 8 Fader Strips (faders, SEL, CUT & SOLO) ip between
controlling analogue levels and track faders within the DAW.
Select the DAW switch, on the Control Surface Panel, to ip all
8 Fader Strips to the DAW layer:
Deselect DAW (not illuminated) to control the analogue layer.
Control Surface Panel Overview