Datasheet

1 – Dual AC inlets with cable clips 2 – Dual locking EtherCon Ethernet connectors 3 – Primary and secondary Mini
DigiLink connectors to Pro Tools 4 – Loop Sync I/O 5 – Word Clock I/O
Ethernet-based audio networking technology makes the need for complex, bulky and expensive
analogue multiway cables a thing of the past. Connected to Pro Tools|HD with RedNet HD32R,
audio interfaces can be conveniently located anywhere an Ethernet port is available.
Operation
HD32R acts as a 64-channel (32 in/32 out) digital break in/out box, operating in the same way
as a standard interface, and supporting a wide range of Pro Tools|HDX and HD cards. Supported
Pro Tools systems include Pro Tools|HDX, Pro Tools|HD Native, Pro Tools|HD Native Thunderbolt,
and Pro Tools|HD TDM. Up to six HD32R modules can be used with a Pro Tools|HDX system
and three with Pro Tools|HD, allowing the maximum channel count for either. Simply connect the
HD32R to Pro Tools|HD with standard Mini DigiLink connectors.
HD32R allows the use of the low latency performance of Pro Tools|HD cards in place of a RedNet
PCIe card, bringing the full benefi ts of Dante audio-over IP networking and the RedNet product
range to a Pro Tools|HD system. The entire range of Dante-compatible products including the
superb RedNet analogue and digital interfaces can then be used with a Pro Tools|HD system,
all connected via Ethernet cable.
From complex multi-room systems to single installations Dante and RedNet offer the ability
to create a sophisticated and comprehensive high-quality audio production environment around
a standard Ethernet network, with HD32R providing the bridge to any Pro Tools|HD system.
Assign any available Dante source or destination via HD32R and it appears in Pro Tools exactly as
it would with any other Pro Tools-compatible interface, maintaining traditional Pro Tools workfl ows.
Pro Tools|HD is a trademark or registered trademark of Avid Technology, Inc. or its subsidiaries in the United States and/or other countries
Specifi cations
HD32R-DS • v1.1 • 20141001 • REƒwww.focusrite.com/rednet
3 4 521
Related products:
MP8R – 8 Ch. Mic Pre
D64 – MADI Bridge
See the rest of the range at
www.focusrite.com/rednet
D16R – AES3 Bridge
Connectors (Rear panel)
2x etherCON locking Ethernet connectors – also compatible with
standard RJ45 connectors
2x BNC Word Clock In and Out
2x BNC Loop Sync I/O
Primary and Expansion Mini DigiLink connectors to/from Pro
Tools|HD system
2x IEC power connector: 100–240Vac, 50/60 Hz, cord retaining
clips included
Controls (front panel)
Power on/off
Indicators (front panel)
Green LED power indicator
Network Status: Primary/Secondary/Locked
PSU: A/B
Sample rate: 44.1/48kHz, x2, x4, Pull
Signal presence: from/to DAW, LED per 4 channels
Clock Source: Internal, Loop Sync, Word Clock, DAW Master
Supported Systems
Pro Tools|HD PCIe
Pro Tools|HDX
Pro Tools|HD Native PCIe
Pro Tools|HD Native Thunderbolt
Requires Pro Tools|HD 8.0 and up
E&OE