Owner's Manual

INTEGRATION UNIVERSAL
Manuel
d'utilisation
I
User
manual
•
Connecting the
tweeter
I
woofer to the connector of the integrated crossover : (Fig.
D)
For the tweeter: connect both wires [Fig.D1
I directly to the cable lugs
on
the integrated crossover.
For the woofer: connect the two cable lugs
on
the integrated crossover
[Fig.D21
directly to the two
terminals
on
the basket of
the
woofer.
Note:
the"+"
is indicated
by
a red line.
Caution: the
tweeter
crossover is integrated into the connector. Ensure that the
wiring
is correct using the cable lugs
(tweeter/crossover connector) in
order
to ensure optimal performance of the kits.
The woofers in the
ISU130, ISU165, ISU200, ISU570
and
ISU690
kits are equipped
with
a crossover integrated into the
connector (for a more compact basket and one which is easy to
install
in factory locations).
Make sure that
ONLY
the connectors supplied
with
the
kit
are used.
Installing the different woofers
[Fig.EI
represents the typical installation for the
ISU
130,
ISU
165,
ISU200, ISU570
and
ISU690
speaker drivers.
[Fig .
E1
I
Fix
the speaker driver
in
place using the screws provided.
[Fig.
E21
represents the speaker driver once fixed
in
place.
[Fig.FI
represents the typical installation for the
ICU
100,
ICU
130,
ICU
165
and ICU570
speaker drivers.
[Fig.F1 I
Fix the speaker driver in place using the screws provided.
[Fig.F2] represents the speaker driver once fixed in place.
[Fig.GI represents the typical installation of the
ICU690
speaker driver with its grille.
[Fig.G 1
I Insert the grille's plastic support onto the rear of the speaker driver. Fix the speaker driver in place using the screws
provided, then, clip
on
the
grille
supplied
·
[Fig.
G21
represents the speaker driver once fixed in place and with its protective grille.
Adjusting
the
tweeter
level
(ICU
1
00,
ICU
130,
ICU
165, ICU570, ICU690)
The
integrated tweeter
on
the coaxial speaker drivers is equipped with a level adjustment, giving
you
the choice out of two output
levels for the treble [Fig.
H.]
:
View
of
the
full
installation
in
the
vehicle
[Fig.ll represents
an
example of a
full
installation of a component kit
[ISU
130,
ISU
165,
ISU200, ISU570, ISU690I
[Fig.JI
represents
an
example of a
full
installation of a coaxial kit
[ICU100, ICU130, ICU165, ICU570, ICU690l
If
all
the speaker drivers are located
in
the lower part of the door,
we
recommend setting the tweeter
to
''HIGH"
to increase the
treble level.
If
the speaker drivers are located in the upper part of the door, we recommend setting the tweeter to
"FLAT".
Note : of course,
you
can always adjust these settings according to your personal preference.