Installation Guide

12 Arentzen Blvd.

Charleroi, PA 15022

800-662-5550

www.focalpointproducts.com

MEDALLION INSTALLATION

1. Prefinish

Apply desired paint finish before installing. Minor touch up can be

made once medallion is installed. (Do not use lacquer based paints)

2. Cutting Center Hole

If medallion has no center hole drill hole in the center using a spade

or twist bit. The hole should be large enough to allow wiring and

threaded bolt(s) to pass through.

3. Hanging Medallion

A. Before connecting wires (1) to power source, slip the medallion

over hanger bar or chain of fixture (2). Screw the medallion to the

wallboard using trim head screws (3).

Note: On plaster ceilings it may be necessary to use toggle bolts or hollow

wall anchors. Pre-drill medallion.

B. Connect fixture wires to power source and hang fixture according

to manufacturer’s instructions. Slide loop ring (4) up hanger bar and

secure firmly in place, tightening loop ring. Canopy (5) is optional.

Note: Because some of the screws supplied with canopy covers are not long

enough to screw into the ceiling when a medallion is used, you may need to

purchase longer screws

4. Final Touch-Up

Countersink nails and fill with spackle. Use paintable caulk where the

medallion meets the ceiling. Prime, where necessary, and paint with

any high quality latex or oil based paint.

Important Information

Your Focal Point ceiling medallion functions as a decorative element only, and is not

designed to serve as a support for your fixture or fan.

Focal Point advises that you first check local electrical codes on the use of medallions

before installing.

When installing your medallion over an existing fixture, it is necessary to disconnect

and take the fixture down.

Always turn off the electricity at the fuse or circuit breaker box before proceeding

with any installation.

Please Read

And Follow All

Installation

Instructions

Carefully