User's Instructions

// 9.0 PREPARING THE APPLIANCE
For a two or three-sided installation
// 8.2 INSTALLATION – FLOATING
Floating installation continued
17) Underneath the appliance, with the surround screws,
screw up through the bottom surround and into the
legs of the surround top section and up through the
floating shelf brackets on the appliance the top section.
For a two-sided installation, add
one of the blanking plates and
secure with the six firebox screws
into position. Next add the two
small trims and the large trim to
the side of the appliance. Then
line the holes of the trims with
the corresponding holes of the
firebox and screw into position
with the six countersunk screws,
previously removed.
For a three-sided installation,
secure the small and large trims
on both ends of the appliance in
line with the corresponding holes
of the firebox. Secure into position
with the 12 supplied firebox
screws, six on each side.
Crosshead screws
Blanking Plate
Firebox screws
Small trim
Small trim
Large trim
We strongly recommend that two people are
used to remove the glass, both using protective
gloves.
To remove the front glass from
the appliance, use a cross headed
screwdriver to remove the screws
from either end of the top bracket
of the appliance, holding the glass
in place.
Ensure the glass is supported at all times.
Next, gently leaver the top of the
glass towards you, ensuring you
have full support of the glass.
Lift the glass up and out from the
appliance and place the glass on a
soft, flat surface on the floor.
Insert your preferred fuel bed
options as shown in the following
pages in section 10.0 – 10.2.
To re-install the glass, see the
instructions in reverse order.
16) Carefully lower the top section of the surround onto the
top of the firebox.
18) Install the bottom panel onto the underside to the
surround with the four surround screws left over.
// 13
// 14© 2020 British Fires