User's Instructions

// 2.0 GROUNDING INSTRUCTIONS // 3.0 APPLIANCE DATA FOR THE NEW FOREST ELECTRIC FIRE
EF40-48B
This heater is for use on 120 volts. The cord has a
plug as shown at (A) in figure below. An adaptor as
shown at (C) is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The
green grounding lug extending from the adaptor
must be connected to a permanent ground such as a
properly grounded outlet box.
The adaptor should not be used if a three-slot
grounded receptacle is available.
Weight (lb.s) 84.2 lbs.
Dimensions (in.) H 22.1 x W 47.2 x D 11.7 in.
Supply Voltage and Rating Power 120V AC, 60Hz 1500W
Heating Elements 1500 W
Lighting LED
Item Symbol Value Unit Item Unit Item Unit
Heat Output Types of heat input, for electric storage local space heaters only Other control options
Nominal heat output Pnom 1.5 KW Manual heat charge control with integrated thermostat N/A
Room temperature control
with presence detection
No
Minimum heat output (indicative) Pmin 0.75 KW
Manual heat charge control with room
and/or outdoor temp. feedback
N/A
Room temperature control
with open window detection
Yes
Maximum continuous heat output Pmax, c 1.5 KW
Electronic heat charge control with room
and/or outdoor temp. feedback
N/A With distance control option No
Fan assisted heat output N/A With adaptive start control No
With black bulb sensor No
Auxiliary electricity consumption Type of heat output/room temperature control
At nominal heat output elmax 0.0 KW Single stage heat output and no room temperature control No
At minimum heat output elmin 0.0 KW Two or more manual stages no temperature control No
In standby mode elSB 0.0 KW With mechanical thermostat room temperature control Yes
With electronic room temperature control No
Electronic room temperature control plus day timer Yes
Electronic room temperature control plus week timer Yes
This fire is fitted with LED’s (Light Emitting Diode) in
place of conventional bulbs. LED’s generate the same
light levels as conventional bulbs, but use a fraction of
the energy consumed.
// WARNING:
Before enclosing the appliance, test the power in situation
in order to ensure the power to the appliance working properly.
// NOTE:
Adaptors are NOT for use in Canada
// 1.0 IMPORTANT NOTES
Important Notes Continued
try to correct the interference
by one or more of the following
measures:
Reorient or relocate the
receiving antenna.-- Increase
the separation between the
equipment and receiver.
Connect the equipment into
an outlet on a circuit different
from that to which the receiver
is connected.
Consult the dealer or an
experienced radio/TV technician
for help.
FCC Radiation Exposure Statement:
This equipment complies with
FCC radiation exposure limits
set forth for an uncontrolled
environment.
This equipment should be
installed and operated with a
minimum distance of 20cm
between the radiator and your
body.
This transmitter must not
be co-located or operating in
conjunction with any other
antenna or transmitter.
// 03
// 04© 2020 British Fires