Operation Manual

18 | P a g e
To disable a tire sensor:-
1. Select “Disable/Install Sensor” at the bike status screen setting.
2. Long press the box corresponding to the tire position you want to disable until a
prompt message appears in 5 to 10 seconds. Due to variation in phone models,
glass surface and finger conditions, the prompt message may take longer to
appear or may not appear. Please readjust finger position and long press again.
3. Click OK on the message box to disable the sensor.
4. You will see “Disabled” inside the box corresponding to the disabled tire
position, the box will be greyed out too. Take note that FOBO Bike will stop
monitoring tire for a disabled sensor position.
To install a replacement tire sensor:-
1. Select “Disable/Install Sensor” at the bike status screen setting.
2. Long press the box corresponding to the tire position you want to install until a
prompt message appears in 5 to 10 seconds. This would be the box with the
text “Disabled” for the sensor that you had previously disabled.
3. Click OK on the message box to install the sensor. You will be prompted to
screw on the sensor to the tire valve and hold your smartphone touching the
sensor.
4. You will be prompted that the sensor has been successfully installed and you can
immediately use it.
NOTE: You can only install a replacement sensor after the tire position has
been “Disabled”. You can purchase replacement sensors online from www.my-
fobo.com.
5.6 Release and Uninstall FOBO Bike
To release and uninstall FOBO Bike, do the following steps:-
1. At the Home screen, select the Bike that you want to uninstall/release.
2. Tap the settings icon at the top left of the screen.
3. Select “Release Bike Sensors” and follow the instruction on the screen.
4. You will see “Released” in the corresponding boxes of the released sensor.
5. Repeat step 2 to 4 for the remaining sensors.
6. After all the corresponding boxes are shown “Released”, go back to the home
screen.
7. Swipe right to left on the Bike profile that you wish to remove and click on
„Delete‟ which will appear after you swipe.
NOTE: Do not delete your Bike profile before releasing the sensors. If you have
accidentally done so, re-install the sensors to the same FOBO account and
follow the release procedure above to properly release the sensors.