Users Manual

EN
The green light is always on Jump starter is quickly discharging
• Please confirm whether both red and black
clips are connected well (short circuit).
• Please check if the positive (red) electrode
and negative (black) electrode connection
are reversed.
• The jumper starter is in low power and needs
to be charged in time.
• Back charge protection, the voltage of the
car battery is higher than 12.6V.
• No jump starter needed, the car battery is
enough to star
your car.
• The temperature of the clamp exceeds
65(+/-5)degrees.
• Rem
ove
the clamp untill the red green
led flash.
The red light is always on
(warning)
The red light flashes
1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles,or it will cause serious damages to the unit.
4. Do not jump start your car when the battery capacity is lower than 50%.
5. Do not connect two clamps toget
her when the starter is powered on.And
do not connect both cable clamps to the same piece of metal.
6. If the engine does not start on the first try, disconnect the jumper from the
car battery and wait for at least 20 seconds before reconnecting. Maximize
three attempts in two minutes.
7. Once the engine is successfully started,disconnect the clamps within 30
seconds.