User's Guide

Overview of SNAP G features
17
Head tacker button/buzzer operation
Refer to the table below for using the head tracker button.
Product operation Button operation LED status
Buzzer after connecting
the product
Power on/connection
standby state
Press for 2 seconds
(power off)
White LED on No sound
Power off
Long press
(power on)
Off 2 short + 1 long buzz
Attempting to connect to
the product
- White LED flickers 1 short buzz each second
Completed connection
with the product
-
Blue LED flickers once
every 3 seconds
1 short + 1 long buzz
Viewpoint correction start Double press Blue LED on 1 long + 1 short buzz
Viewpoint correction
complete
Double press
(after entering viewpoint
correction)
Blue LED flickers once
every 3 seconds
1 long buzz
Calibration start/in
progress
Short press and long press
or three short presses
White LED flickers once
every 2 seconds
1 long + 2 short buzzes
Calibration complete - - 1 long buzz
Shooting photo
Short press
(power on)
Blue LED flickers twice 1 short buzz
Recording video Blue LED flickers 2 short buzzes
Stop recording video
Blue LED flickers once
every 3 seconds
3 short buzzes
Low battery - Red LED flickers 2 short buzzes per second
Charging - Red LED on No sound
Charging complete - Off No sound
• Head tracker button operation is subject to change.
• Button operation and buzzer sound are subject to change.
3.5 Using dynamic motion recording mode
Withthedynamicmotionfunction,youcanspecifyupto4recordingpoints,andsetthepathandtimeto
record before recording.
Dynamic motion recording mode
1
On the Video Preview screen, touch the ( ) button
>
motion settings.
2
Set the time to record. The video length is automatically calculated and displayed based on the video
settings value (speed, interval).
3
After setting the recording time, touch the ( ) button to return to the Motion Settings screen, and
then touch the (
) button in the upper-right corner to move to the Route Settings screen.