User Manual

IMPORTANT NOTE:
This device is intended only for OEM integrators under the following conditions:
(1) According to FCC Part 15 Subpart C Section 15.212, the radio elements of the modular
transmitter must have their own shielding. However, due to there is no shielding for this WIFI/BT
module, this module is granted as a Limited Modular Approval.
(2) Integration is typically strictly restricted to Grantee himself or dedicated OEM integrators
under control of the Grantee.
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter. then the FCC authorization is no longer considered valid
and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
The module will be responsible to satisfy SAR/RF Exposure requirements, when the module
integrated into any (portable, mobile, fixed) host device.
This module is intended for OEM integrator only and the OEM integrators and instructed to
ensure that the end user has no manual instructions to remove or install the device. The OEM
integrator is still responsible for the FCC compliance requirement of the end product, which
integrates this module.
The module has no shielding and tested stand alone. This module is tested and approved as
Limited modular approval with stand alone configuration, any OEM incorporated this radio
module into any system are require additional testing and evaluation.
This module has been designed to operate with a PIFA antenna having a maximum gain of
2.99dBi. Only this type of antenna may be used, the manufacturer recommended antenna as
below:
No. Brand Model name
Antenna
Ty
pe
Connector
Gain
(dBi)
1
ZHONGTIAN
XUN
2.00001213 PIFA I-PEX 2.99
2 XK
XKFPC-2D4-5D8-1
50
PIF
A I-PEX 0.0
3 XK
XK-QX2400-
PCB-1
40
PIFA I-PEX 2.0
4
ZHONGTIAN
XUN
2.00001050 PIF
A I-PEX 0.38
The module must in the end-product be installed in such manner that the authorized antennas
can be used, any change of the antenna will void the certification.
EU Regulatory Conformance
Hereby, we(FN-LINK TECHNOLOGY LIMITED) declared that this device is in compliance with
the essential requirements and other relevant provisions of Directive 2014/53/EU
FN-LINK TECHNOLOGY LIMITED
16
Proprietary & Confidential Information