User Manual

WARING:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. (2) This device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
LABEL OF THE END PRODUCT:
The final end product must be labelled in a visible area with the following "Contains TX FCC ID:
2AATL-6110R-IF". If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19
statement is required to be available in the users manual: This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
RF Exposure
This device has been evaluated and shown compliant with the FCC RF Exposure limits under fixed
exposure conditions (antennas are greater than 20cm from a person's body) when installed in certain
specific OEM configurations.
IMPORTANT NOTE:
Integration is typically strictly restricted to Grantee himself or dedicated OEM integrators under control
of the Grantee. The module will be responsible to satisfy SAR/RF Exposure requirements, when the
module integrated into any (portable, mobile, fixed) host device. This module is intended for OEM
integrator only and the OEM integrators and instructed to ensure that the end user has no manual
instructions to remove or install the device. The OEM integrator is still responsible for the FCC
compliance requirement of the end product, which integrates this module.
EU Regulatory Conformance
Hereby, we (FN-Link Technology Limited) declared that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.