Owner’s Manual 2007

29
4.8. Unloading the pistol
u If the hammer is cocked, decock it as described in Section 4.5.
v Press the magazine release in order to eject the magazine.
If the magazine does not pop out, pull on its bottom plate.
w Pull the slide fully rearward in order to eject the remaining
cartridge from the chamber and then release the slide.
If the slide is already automatically locked into the rearward position after
having fired the last cartridge, this step should be skipped.
Do not forget to pick-up, clean and store the ejected cartridge.
x Pull the slide fully rearward, lock it into its rear position by
using the slide stop, and then ensure via the ejection port that
the chamber is completely empty.
y Release the slide by pushing downward on the slide stop, and
then let the slide move forwards under control.
z Decock the hammer as described in Section 4.5.
{ Unload the magazine by removing the cartridges one by one.
Slightly push down on the rear part of the top cartridge and then carefully
push it out to release it from the lips of the magazine.
Repeat this procedure until the magazine is completely empty.
Unload the spare magazines.
| Insert the empty magazine back into the pistol.
If the pistol will be stored in its storage box, do not insert the empty
magazine. The pistol and the magazine are stored separately in the box.