Owner’s Manual 2007

4.5. Decocking the hammer

If you do not intend to ﬁre immediately, and in order to obtain the most safe

condition, the pistol should be set for double-action shooting which means

that the hammer should be decocked.

If it is necessary to decock the hammer, proceed as follows:

u Point the pistol in a safe direction.

v Without touching the

trigger, push down on the

left or right decocking

lever with your thumb.

As a result, the hammer will

move towards the decocked

position where it is halted

without ﬁring.

During this operation, a

mechanical blockage of the

ﬁring pin takes place.

After this operation, the pistol can still be ﬁred by pulling the trigger.

Firing will require a longer and heavier pull on the trigger.

NEVER TRY TO COCK THE HAMMER BY PULLING THE TRIGGER.

ONLY FOR LAW ENFORCEMENT AND MILITARY USE !

THE HAMMER CAN BE COCKED MANUALLY BY USING THE THUMB OF

THE SHOOTING HAND SO THAT THE PISTOL CAN BE SET FROM DOUBLE-

ACTION TO SINGLE-ACTION WITHOUT HAVING TO MOVE THE SLIDE (I.E.

WHEN NOISE SUPPRESSION IS AN ISSUE).

Delocking Lever