Owner’s Manual Addendum 2013

3
6. Place the cheekpiece back on the buttstock by
aligning the stock adjustment studs with the
inserts. The cheekpiece will now stop on the
stop screws that you have backed out to the
recorded height. Use the 3mm hex wrench to
tighten down the cheekpiece locking screws on
the right side of the stock. Do not over tighten.
2.2 Adjusting Cast On and Cast Off
Just like adjusting the comb, adjusting the cast allows you to align your eye perfectly with the scope or sights you
may install on the rifle. A properly adjusted comb will provide increased accuracy and shooter comfort. To adjust
the cast of the comb:
1. Loosen the cheekpiece locking screws on the right side of the stock using the supplied 3mm hex wrench
as described in step 1 from above. The proper height should be recorded if step 5 from above was
accomplished. Remove the cheekpiece by pulling it up and off the buttstock.
2. On the bottom of the cheekpiece, the two stock adjustment studs
attach to the mounting plate. They can be loosened using the
3mm hex wrench. It is not necessary to remove the screw. Each
one of them can now be slide left or right on the mounting plate.
3. Each stud has an index line that will align with the graduated
index lines on the mounting plate. Slide each of the studs left
or right in its groove until the desired cast on or off is obtained.
Lightly tighten the studs.